Eco Driving and Railcrossing
- 1/20Harmful effects of vehicle emissions
Truck and delivery van emissions release nitrogen oxides and particulates, which affect urban air quality and increase respiratory illnesses. Emission regulations aim to reduce this impact.
Avoid topping off the gas tank
In the Netherlands, drivers are advised not to top off the tank to prevent fuel overflow and vapor release, which harms the environment and damages the vapor recovery system.
Turn off the engine if parked more than 10 seconds
You are stopped for more than 10 seconds except in traffic, turn off the engine. This reduces CO₂ emissions and supports Dutch fuel-saving practices.
Maintain proper tire pressure and alignment
Regular checks of tire pressure and alignment improve rolling efficiency, extend tire life, and reduce CO₂ output. Low pressure increases fuel use by 2 to 4%.
Use engine braking on downhill slopes
Dutch driver training emphasizes engine braking during descents to control speed, reduce brake wear, and enhance fuel economy in trucks and vans.
Keep a safe following distance
Dutch road safety guidelines recommend a 2-second minimum distance from the vehicle ahead to allow safe braking and prevent rear-end collisions, especially on motorways.
Avoid pressing the accelerator during engine start
Starting the engine without unnecessary throttle prevents flooding and reduces emissions, as emphasized in Dutch eco-driving practices.
Limit engine warm-up to under 1 minute
In cold Dutch climates, drivers are advised to drive gently after starting the engine instead of idling, which saves fuel and reduces CO₂ output.
Shift gears smoothly and efficiently
Netherlands driving instruction promotes steady gear changes to reduce engine strain and improve vehicle fuel economy, especially in trucks and buses.
Use the clutch when changing gears
In commercial vehicles, clutchless shifting can cause transmission failure and is not permitted under Dutch driving regulations and inspection standards.
When approaching a railway crossing with flashing signal lights
In the Netherlands, flashing red lights at a level crossing indicate a train is coming. Drivers must stop and wait until the lights go off and the barriers lift before proceeding.
If no signals or gates are present at a railway crossing
Dutch road safety rules require drivers to approach unprotected crossings with caution, watching for trains before crossing even if no signs are active.
If you get trapped on a railway crossing
Dutch emergency protocol instructs drivers to abandon the vehicle and run at a 45-degree angle away from the tracks in the direction of the oncoming train to avoid debris.
If a train is approaching and you are on the tracks
Immediate evacuation is required under Dutch regulations. Never attempt to reverse or turn on the tracks when a train is visible.
Common causes of vehicle fires
The Netherlands vehicle inspection guide cites poor maintenance, damaged wiring, and brake overheating as top causes of commercial vehicle fires.
If your vehicle catches fire
According to Dutch emergency procedures, the driver must stop safely, evacuate all passengers, and call 112. Do not attempt to extinguish large fires yourself.
If you detect smoke or fire from your engine or wheels
Dutch regulations require immediate attention to overheating or smoke from tires, brakes, or engine compartments to prevent escalation. Use a fire extinguisher only if safe.
Harmful effects of vehicle emissions
Dutch environmental authorities emphasize reducing CO₂, NOx, and particulate emissions, which harm public health and the environment.
Avoid this when parked for more than 10 seconds
Idling is discouraged in the Netherlands as it wastes fuel and increases pollution. Turn off the engine if stopped for more than 10 seconds.
A good practice for maintaining fuel efficiency
The Dutch fuel efficiency guide recommends smooth driving and regular maintenance to reduce fuel use and emissions.